- Single Row Angular Contact Bearing, 40 mm ID x 90 mm OD x 23 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
| icNumber | 7695815 |
| Precision | Standard |
| Inch/Metric | Metric Bore |
| Radial Internal Clearance | Normal |
| Enclosure | Open |
| Temperature Range [Max] | 450 °F |
| Limiting Speed - Oil | 9500 rpm |
| Radial Internal Clearance Specification | Normal Clearance |
| Material | Steel |
| Series | 7300PJ |
| Seal Type | Unsealed |
| No. in Set | Single Bearing |
| Static Load Rating [Max] | 6860 lbf |
| O.D. | 90 mm |
| Cage Type | Metal |
| Outer Ring Width | 23 mm |
| Bore Type | Round Bore |
| Width | 23.000 mm |
| Preload Level | None |
| Cage Material | Brass/Bronze |
| Ball Material | Steel |
| Dynamic Load Rating | 9940 lbf |
| Contact Angle | 40° |
| Limiting Speed - Grease | 7300 rpm |
| Precision Level | Standard (ABEC 1) |
| O.D. Type | Straight |
| Inner Ring Width | 23 mm |
| Capacity | Standard Capacity |
| Static Load Rating | 33.5 kN |
| Internal Design | Universal Mounting |
| I.D. | 40 mm |
| Seal Material | None |
| Origin | Single Row Angular Contact |
| Flush Ground | Yes |
| Snap Ring | No Snap Ring |
| Fillet Radius | 1.5 mm |
| Locking Device | No Locking Device |
| Rows of Balls | Single |
| Bearing Type | Angular Contact |
| Lubricant | Oil Preservative |
| Weight | 1.541 LB |
| EAN or UPC | 97741017497 |

