6218DDUC3

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761654

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

O.D. Type	Straight
Limiting Speed - Grease	2600 rpm
Dynamic Load Rating	21,582.00 lbf
Outer Ring Width	30 mm
Lubricant	Mul-Temp SRL
Ball Material	Steel
Preload Level	None
O.D.	160.0000 mm
Capacity	Standard Capacity
Enclosure	Double Sealed
Contact Angle	0°
Locking Device	No Locking Device
Seal Material	Buna-N
Precision Level	Standard (ABEC 1)
Radial Internal Clearance	C3
Radial Internal Clearance Specification	Greater Than Normal Clearance
Seal Type	Contact Seals
I.D.	90 mm
Material	Steel
Cage Type	Metal
Bore Type	Round Bore
Rows of Balls	Single
Bearing Type	Radial
Limiting Speed - Oil	4800 rpm
Width	30 mm
Corner Radius [Min]	2.00 mm
Static Load Rating [Max]	16,074.00 lbf
Inch/Metric	Metric Bore
No. in Set	Single Bearing
Snap Ring	No Snap Ring
Inner Ring Width	30 mm
Cage Material	Pressed Steel
Precision	Standard
Weight	4.769 LB
EAN or UPC	29176064845