HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100761522

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Lubricant	Mul-Temp SRL
O.D.	140.0000 mm
Radial Internal Clearance	C3
Inch/Metric	Metric Bore
Precision Level	Standard (ABEC 1)
Material	Steel
Radial Internal Clearance Specification	Greater Than Normal Clearance
I.D.	65 mm
Cage Type	Metal
O.D. Type	Straight
Width	33 mm
Capacity	Standard Capacity
icNumber	7695944
Snap Ring	No Snap Ring
Seal Type	Unsealed
Dynamic Load Rating	21,835.00 lbf
Corner Radius [Min]	2.10 mm
Outer Ring Width	33 mm
Cage Material	Pressed Steel
Bearing Type	Radial
Limiting Speed - Oil	6000 rpm
Static Load Rating [Max]	13,450.00 lbf
Inner Ring Width	33 mm
Limiting Speed - Grease	4800 rpm
No. in Set	Single Bearing
Rows of Balls	Single
Locking Device	No Locking Device
Bore Type	Round Bore
Precision	Standard
Seal Material	None
Preload Level	None
Enclosure	Open
Ball Material	Steel
Contact Angle	0°
Weight	4.569 LB
EAN or UPC	29176021046