TMMD 100

description

• Easy dismounting of ball bearings in blind housings. The SKF TMMD 100 is specially designed to allow easy and quick dismounting of deep groove ball bearings with interference fit on both rings. The puller is suitable for use in both blind housings and shaft applications. In addition to dismounting open bearings, the TMMD 100 can be used to dismount sealed bearings after the removal of the seal. The TMMD 100 is suitable for dismounting up to 71 different SKF deep groove ball bearings from shaft diameters, ranging between 10 to 100 mm (0.4 to 3.9 in).

features

• Claws are specially designed to facilitate a precise fit in bearing's raceways, providing good grip and allowing application of higher dismounting forces
• Each puller arm is fitted with a spring for easy installation
• Puller arms are made of single-piece, laser-cut, hardened steel for strength and longevity
• Arm sizes 4, 5 and 6 are fitted with filling plates to accommodate a wide range of bearings
• Spindle's hexagon head is equipped with an antislip pin, which prevents spanner from sliding down spindle during dismounting
• Claw's rotation angle is limited to allow easy installation
• Designation is laser engraved on arms, allowing easy identification and selection

includes

• Six sets of different-sized puller arms
• Two spindles
• One handle (packed in a carrying case)