- Single Row Angular Contact Bearing, 25 mm ID x 80 mm OD x 21 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7400-PJ and PJD Series bearings are similar to the 7200-PJ and 7300-PH Series but are heavier sectioned and are used for very heavy thrust loads or combined radial and thrust loads where thrust is predominant.
| Material | Steel |
| O.D. | 80 mm |
| Origin | Single Row Angular Contact |
| Cage Type | Metal |
| Dynamic Load Rating | 9510 lbf |
| Cage Material | Brass/Bronze |
| I.D. | 25 mm |
| Limiting Speed - Grease | 9200 rpm |
| Radial Internal Clearance Specification | Normal Clearance |
| Radial Internal Clearance | Normal |
| No. in Set | Single Bearing |
| Preload Level | None |
| Snap Ring | No Snap Ring |
| Static Load Rating | 23.6 kN |
| Lubricant | Oil Preservative |
| Fillet Radius | 1.5 mm |
| Enclosure | Open |
| Series | 7400PJ |
| O.D. Type | Straight |
| Ball Material | Steel |
| Locking Device | No Locking Device |
| Limiting Speed - Oil | 12000 rpm |
| Bore Type | Round Bore |
| Flush Ground | Yes |
| Precision | Standard |
| Precision Level | Standard (ABEC 1) |
| Outer Ring Width | 21 mm |
| Seal Type | Unsealed |
| Capacity | Standard Capacity |
| Static Load Rating [Max] | 5510 lbf |
| Seal Material | None |
| Rows of Balls | Single |
| Contact Angle | 40° |
| Temperature Range [Max] | 450 °F |
| Width | 21.000 mm |
| Bearing Type | Angular Contact |
| Inner Ring Width | 21 mm |
| icNumber | 7695985 |
| Inch/Metric | Metric Bore |
| Internal Design | Universal Mounting |
| Weight | 1.332 LB |
| EAN or UPC | 97741018333 |

