SDBC-10

features

• For use on Tigerflex hoses with convoluted cover (counter-clockwise spiral only)
• For adequate holding power, a single clamp may be used on each end for 1 1/2" to 4" I.D. hose
• Two clamps are recommended for each end on 5" I.D. hose and larger
• Use of pneumatic air tools for tightening purposes is not recommended due to potential clamp damage caused by excess torque
• Both hex nuts should be tightened equally to prevent possible leakage
• If sockets are used, they should be deep well sockets
• Proper evaluation of holding power for clamp must be determined for each individual installation